Fuse Monitor IP 9075 The fuse monitors IL/IP/SL/SP 9075 of the VARIMETER series monitor up to 3 load fuses. Early detection of blown fuses, even when loads are switched off, and preventive maintenance prevent costly damage and, as a user, you benefit from the operational reliability and high availability of your system. Advantages . Increased system availability through early detection of fuse failures, which can cause considerable damage to systems . Rapid detection of fuse failures, even when consumers are switched off, ensures system availability at the earliest possible point in time . Reliable detection of fuse failure, even with an unbalanced or harmonic network and with regenerative motors Features . According to IEC/EN 60255-1 . Recognizes fuse failures in three-phase mains up to 3 AC 690 V . Can be used for all types and sizes of fuses . Independent of phase sequence . Shorter response time than with motor circuit-breakers . As option: - Energized on trip (output relay activated in the event of a fault) - De-energized on trip (output relay not activated in the event of a fault) with IP 9075 programmable via X4-X5 or X3-X4 . As option with manual reset function and remote reset, programmable via X1-X2 . 2 LED indicators . As option: 1 NO contact or 2 changeover contacts . Devices available in 2 enclosure versions: I-model: Depth 59 mm, with terminals at the bottom for installation systems and industrial distribution systems according to DIN 43880 S-model: Depth 98 mm, with terminals at the top for cabinets with mounting plate and cable duct . IL 9075, SL 9075: Width 35 mm IP 9075, SP 9075: Width 70 mm Technical specifications Width: 70mm Enclosure design: Distribution board 1- / 3-phase: 3 Standard measuring range: 3 AC 380 - 415 V Measuring range max.: 690 V Output contacts: 2 C/O contacts Type: IP 9075 Manufacturer: E. Dold & Söhne GmbH & Co. KG Type: IP9075.12 AC50...400HZ 480-550V Art. No.: 0043896